BW/BWS Series Indicator Technical Manual
- 8 -
5. OPERATION
Initial Start-up
Warm-up time of 15 minutes stabilizes the measured values after switching on.
5.1. Basic Operation
1. Power On/Off:
Switch on the balance by pressing on/ off key.
The display is switched on and the test is started and if want to switched
off, press again the key.
2. Zero
Environmental conditions can lead to the balance exactly zero in spite of
the platform not taking any strain. However, you can set the display of
your balance to zero any time by pressing
key and therefore ensure
that the weighing starts at zero.
3. Tare
The weight of any container can be tared by pressing
button so that
with subsequent weighing the net weight of the object being weighed is
always displayed.
Load weight on the platform.
Press
key. Zero is displayed, and tare is subtracted.
Remove weight on the platform. Tared weight is displayed. It can set only
one tare value. It will be shown with a minus value.
Press G/N to change between gross weight and net weight.
To clear the tare value, remove the load and press
key. Zero is
displayed, tare weight is cleared.
4. Select Unit and Sampling operation
Press
key, it can change unit and sampling operation.
