Sahara S375, Manual

Page 16

Connecting to the Cylinder

• Confirm all barbecue control knobs are in the off position.

• Connect the regulator to the gas bottle according to your regulator and bottle dealer’s instructions.

Use Instructions

Before proceeding, make certain that you understand the WARNINGS section of this manual.

• Preparation before cooking – To prevent foods from sticking to the cooking grill, it is recommended to 

apply a light coat of cooking oil to the food before placing on the grill.

• Note: When cooking for the first time, paint colours may change slightly as a result of high

temperatures. This is normal and should be expected.

To Light (main burners)

1. Open the barbecue lid and turn on gas supply at gas cylinder.

2. Push control dial in and slowly turn to “    ” position.

3. If burner does not light, return to OFF position and try again.

4. Once ignition has occured, hold dial in for at least 10 seconds to ensure the burner stays lit.

5. If burner does not light or stay lit after holding dial in for 10 seconds, turn the dial to OFF position and 

    wait for 1 minute and try again. Do not continuously hold the dial in as you may cause a build up of gas.

6. In windy conditions shield from wind to ensure easy lighting.

7. Turn control dial to alter burner settings as required.
After ignition, the burners should be burned at the low position for 3-5minutes in order to preheat the barbecue. 

After completion of preheating, turn burners to low position and close hood for best cooking results.

To Light (side burner)

1. Open the side burner lid and turn on gas supply at gas cylinder.

2. Push control dial in and slowly turn to      position.

3. If burner does not light, return to OFF position and try again.

4. Once ignition has occured, hold dial in for at least 10 seconds to ensure the burner stays lit.

5. If burner does not light or stay lit after holding dial in for 10 seconds, turn the dial to OFF position and  

    wait for 1 minute and try again. Do not continuously hold the dial in as you may cause a build up of gas.

6. In windy conditions shield from wind to ensure easy lighting.

7. Turn control dial to alter burner settings as required.

Manual Lighting Instructions

• Remove the cooking grill, searing grill and vapour bars from barbecue.

• Place a lit match beside the burner (at the same location as the sparker shield)

• Push and turn the right most control knob anti-clockwise to the high position.

• After successful lighting, light each burner from left to right as desired.

• If burner fails to ignite after repeated attempts, contact the help line number stated in this manual.

Grill Cooking

The Vapour bar evenly distributes the heat across the cooking grill area. The natural food juices

produced during cooking fall onto the hot vapour bar below and vapourise. Even cooking of food will be

achieved by using the barbecue with the hood down. This should only be done with the burner on low.

Flare-Up Control

IMPORTANT – FLARE UPS CAN OCCUR FROM RESIDUE FAT AND JUICES DRIPPING ONTO THE

BURNERS AND HOT VAPOUR BAR. To reduce this, regularly clean the burners and vapour bar. To

control flare-up, it is advisable to trim away excess fat from meat and poultry before grilling. The

burners should always be placed on the low setting during cooking. Always protect your hands when

handling anything near cooking surface of the barbecue. 

End of Cooking Session

After each cooking session, open the barbecue lid, turn the barbecue burners to the ‘high’ position and burn 

for 5 minutes. This procedure will burn off cooking residue, thus making cleaning easier.

To Turn Off:

1. Push the dial in and turn to the OFF position.

2. Turn the gas off and disconnect at the cylinder when not in use.