INSTRUCTION MANUAL
Model HC
Reference 219
Rev 2
Page 34 of 46
06/20/2013
2.1.4.5
Changing of afterfilter elements (continued)
C. AF-1400 and above
Isolate the filter by closing the manual valves before and
after the filter.
Completely depressurize the filter.
Open the handhole; be sure to have hold of the
manway cover so as not to lose it into the filter.
Remove the wing nut from the filter top plate(s) and
remove the plate(s).
Remove the element(s) from the filter housing.
Inspect the filter base plate(s), t-bar(s), and filter
union(s) (if applicable). Replace as needed.
Install new element(s) to original position in housing.
Put back cover plate and wing nut.
Inspect o-ring or gasket. Replace if necessary.
Put back cover plate or yoke, then reattach yoke
assembly and tighten.
Slowly repressurize the filter.
Check for air leaks with soap solution.
Place back into service.
2.1.5 Filter
Accessories
Advice: Install pressure differential gauge:
This will indicate the degree to which the elements are soiled and
show when they need to be replaced.
Summary of Contents for Sahara-Pak HC-1260
