INSTRUCTION MANUAL
Sahara Moisture Transmitter
Reference 085
Rev 2
Page 4 of 14
06/06/2013
II.
Making Wiring Connections
You must wire the transmitter using the factory-supplied cable which is available in a
variety of lengths.
Note: If you need to lengthen cables, refer to Table 1 below to splice an extension
onto the existing cable. Connect positive to positive and negative to negative.
Use the following steps to wire the transmitter to your system.
1. Push the female connector end on the transmitter cable into the mating male
connector on the transmitter module. Make sure the pins are properly aligned.
Once inserted, secure the connectors together by sliding the metal sleeve on the
cable over the connectors and turning it clockwise until it is tight.
2. Using the flying leads at the other end of the transmitter cable, connect the
transmitter to your power supply and data acquisition system (DAS) as shown in
Figure 2. Refer to Table 1 for a description of the leads in the factory-supplied
cable.
Figure 2: Wiring Connections
Summary of Contents for Sahara-Pak HC-1260
