7
Copyright. Sygnal 2018
2.6 Turning a zone ON or OFF
1. Press
ZONE
or or to select a zone.
2. Press to turn the zone on or off as required.
2.7 Setting a zone temperature / Position (setpoint)
Zone damper behaviour is determined by whether a zone sensor is connected to the zone sensor output at the
zone control modules. If a sensor is detected the zone is configured for temperature control. If no sensor is
detected and the enable zone dipswitch is turned on the zone is configured for damper positioning control.
1. Press
ZONE
or or to select the target zone.
2. Press
SET
to adjust the target temperature / position.
3. Use or to adjust the set point to the desired level.
4. Press
SET
to save and exit
2.8 Setting a return air temperature
(Only use when all zones are in
Flowset
Mode)
When all zone mode settings =
FlowSet
a return air setpoint is used
1. Press or to select the global screen.
2. Press
SET
to adjust the return air target temperature.
3. Use or to adjust the setpoint to the desired level.
4. Press
SET
to save and exit.
2.9 Naming a Zone
Zone names must be eight characters in length. A blank character must be used to fill spaces where no letters
are required.
1. Press
ZONE
or or to select the zone to be named.
2. Press and hold
SET
for approximately 10 seconds to access the zone name edit function.
3. Use and to view all of the preset zone names (e.g. Lounge, Games etc. or Custom).
4. Press
SET
on your choice. See tip below.
5. Use or to change the first character of the zone name if required.
Set=22.
5°C
Tmp=23.
0°C
Set=85%
Pos=25%
Z1 Name:
(Custom)
Z1 Name:
Games
