Separate ground cable
B-10
Appendix B: Grounding and RF protection
98-136280-B
B.6.2
Ground cable - connection
Mount the ground cable close to and parallel to the shielded coax cable thus
minimizing ground loop problems. If possible, route the coax cable and the ground
cable in metal conduits bonded to the hull or within a mast (depending on the actual
installation).
The ground cable must be connected at one of the mounting/grounding bolts on the
ADU. Use bolts and washers of stainless steel and seal the joint with protective coating
to avoid corrosion. If the ADU is to be isolated from the mounting base, shoulder
bushings and washers must be used — see figure B-7,
At the other end, connect the ground cable as described in
B.6.3
Isolation of the ADU from the mounting base
In cases where the ADU is to be isolated from the mounting base, shoulder bushings
and washers (accessories) must be used as illustrated below. Please note that the
isolation has to be implemented on all four mounting bolts (including the bolt securing
the ground cable).
Figure B-7: Isolation of the ADU from the mounting base
Isolating shoulder bush
Isolating washer
Plain washer
Spring washer
(stainless steel)
(stainless steel)
SAILOR100IM.book Page 10 Friday, January 18, 2013 10:28 AM
Summary of Contents for 100
