2.
INSTALLATION
Before installation of a SAILOR VHF RT2048 the following points must be observed:
1.
Which facilities have to be enabled?
Selcall, private channels, US-mode, dual watch, scanning facilities, etc. The procedure how to enable the
facilities is described in the manual: INSTRUCTIONS FOR IDENTITY AND SERVICE PROGRAMMING OF
SAILOR VHF RT2048.
This manual will only be delivered to dealers and general agents, where it must be at the disposal of trained
service people in the service workshop.
2.
In what way the VHF RT2048 has to be installed?
In the section MOUNTING POSSIBILITIES, the installation of VHF RT2048 is described either as an
independent unit or in combination with the other elements of the Compact 2000 programme.
3.
Handset.
Installation of handset, see the section HANDSET.
4.
External loudspeaker.
An external loudspeaker 4-8 ohm/6W can be connected to the power connector J1, pin 1 and 6, see the
section POWER CON EXT. LOUDSPEAKER.
5.
Special options:
Remote alarm for selcall, AF to information decoder, AUX I and AUX II information, etc. are available, see
the section SPECIAL OPTIONS
9346
Page 2-1
RT2048
Summary of Contents for RT2048 VHF
