Disengage the Clutch i.e.
Posi-Pin Clutch System:
To prepare your machine to wind bobbins,
first disengage the Posi-Pin Clutch System, to
allow for bobbin winding without running the
machine (
4
).
Simply pull the pin out of the balance wheel
and place it in the center hole as shown to
store (
5
).
To continue sewing, re-engage the clutch:
1.
Push the Posi-Pin gently into any of the
three Posi-Pin holes in the balance wheel.
2.
Rotate the balance wheel while lightly
pushing on the Posi-Pin until you feel it
connect with any of the 4 bushing holes.
3.
Push the pin all the way in and release.
Winding Bobbins
A partially wound V-92 bobbin is already
loaded in the machine. Skip this step if you
wish to test sew with the pre-loaded bobbin.
>
Posi-Pin clutch
DISENGAGED
>
Posi-Pin clutch
ENGAGED
Thread the Bobbin
On the machine:
1.
Thread comes off top of cone to thread
stand arm (
A
).
2.
Pass through thread post (
B
).
3.
Wrap around bobbin tensioner (
C
).
4.
Run under and up through a hole in top
of bobbin (
D
). Place bobbin on post and
push to the right. Hold onto thread tail
briefly and power machine with the clutch
disengaged to wind bobbin. Stop after
several rotations and cut the thread tail off
flush with the bobbin side.
5.
Continue winding until the bobbin is full.
Then remove the bobbin from the winder
post by pushing the post to the left and
pulling the bobbin off. Cut the thread.
A
B
C
D
It's faster to wind while you sew!
Run thread to the bobbin winder from an extra
cone of thread. Simply place the second cone
beside the primary cone and lead the thread up
through the same guides. Follow normal bobbin
winding instructions but do not disengage the
clutch.
Ultrafeed
®
Guidebook: Ultrafeed® Set-Up
6
5
www.sailrite.com
