Adjusting the Left-Right Positioning of the Shuttle Gib Hook
1�
Set the machine to straight stitch and place needle in
center position�
2�
Make a mark (
A
) on the shuttle race guide shaft where
the halves of the compressible clamp meet (
B
)� If the
shaft should accidentally rotate, realign the mark with
the clamp gap�
3�
Incrementally loosen screw (
C
) until light taps will
move the shuttle assembly (
D
) in either direction�
4�
Carefully move the assembly to position the hook as
close to the needle as possible without deflecting (
E
)�
5�
With the mark on the shuttle race guide shaft (
A
) and
where the halves of the compressible clamp meet (
B
)
aligned, tighten screw (
C
)�
After adjusting/verifying the correct left-right position of the shuttle gib hook, proceed to check the rotational
positioning of the shuttle race guide shaft (p� 53)�
71
72
72
B
D
A
C
E
73
73
51 |
Sailrite�com
Ultrafeed
®
LSZ Guidebook
| 52
