16
13.
Location division.(default: Northern Hemisphere)
Press the
SET
key again to
change the location division. Press the [+] key or [-] key to toggle the sunlight units
Northern Hemisphere (NOR)or Southern Hemisphere(SOU).(refer to 5.0 Final
Installation of Integrated outdoor transmitter)
7.3 Sensor Search Mode
If Outdoor sensor loses communication, dashes (--.-) will be displayed.
To reacquire the lost signal, press and hold the
CH/+
button for 3 seconds to enter the
sensor search mode.
7.4 Reset Min/Max record
Note:
The minimum and maximum value of all channels will be cleared in the reset
mode.
In normal mode, Press (do not hold) the
MIN/MAX/-
key
,
and the
MAX
icon will be
displayed. Press the
SET
key to view rainfall (1h, 24h, week or month) , pressure (ABS or
REL) max value ,outdoor temperature (temperature, dew point or feels like).
Next, press and hold the
MIN/MAX/-
key for three seconds(and the
CLR
character is
flashing in time area) to clear the rainfall, wind speed, wind gust, pressure, temperature and
humidity maximum values. The maximum values will now display the current values.
Press the
MIN/MAX/-
key again (do not hold), and the
MIN
icon will be displayed. Press
the
SET
key to view pressure (ABS or REL) min value, pressure (ABS or REL) min
value ,outdoor temperature (temperature, dew point or feels like).
Next, Press and hold the
MIN/MAX/-
key for three seconds(and the
CLR
character is
flashing in time area) to clear the pressure, temperature and humidity minimum values.
The minimum values will now display the current values.
Press the
SNOOZE
key to exit the min/max checking and cleaning mode, return to normal
display mode.
7.5 Snooze Mode
If the alarm sounds, and you wish to silence the alarm, press the
SNOOZE
key, the
backlight will turn on. The alarm icon will continue to flash and the alarm will silence for
five minute. press any key (
MIN/MAX/+ ,SET, ALARM,C
) to permanently
exit the
Snooze
mode.
7.6 Back light Mode
If the LED is off, Press the
SNOOZE
button once. The backlight will turn on for five
seconds, and if no operation is performed for three seconds, the backlight will turn off.
The backlight operation is different when operating on batteries to save power.
