- 29 -
The following is a list of the individual alarm parameters that
are set (in order):
Note:
To prevent repetitive temperature alarming, there is a
0.9 °F(0.5
°C
) tolerance band. For example, if you set the high
alarm to 80.0°F(26.7
°C
) and silence the alarm, the alarm icon
will continue to flash until the temperature falls below 80.0°F
(26.7
°C
), at which point, the alarm will reset and must increase
above 80.0°F(26.7
°C
) to activate again.
Note:
To prevent repetitive alarming of humidity, there is a
4% tolerance band in humidity alarm. For example, if you set
the high alarm to 60% and silence the alarm, the alarm icon
will continue to flash until the humidity falls below 56%, at
which point, the alarm will reset and must increase above 60%
to activate again.
1.Alarm hour(alarm 1)
2.Alarm minute(alarm 1)
3.Alarm hour(alarm 2)
4.Alarm minute(alarm 2)
5.Wind Gust HI alarm
6.Wind average HI alarm
7. Wind Direction Alarm
8.Outdoor temp HI alarm
9.Outdoor temp low alarm
10.Outdoor humidity HI alarm
11.Outdoor humidity low alarm
12.Outdoor feels like HI alarm
13.Outdoor feels like low alarm
14.Outdoor dew point HI alarm
15.Outdoor dew point low alarm
16.Rainfall (1h) HI alarm
17.Rainfall (24h) HI alarm
18.Absolute pressure HI alarm
19.Absolute pressure low alarm
20.Relative pressure HI alarm
21.Relative pressure low alarm
22.Indoor temperature HI alarm
23.Indoor temperature low alarm
24.Indoor humidity HI alarm
25.Indoor humidity low alarm
26.Sunlight HI alarm
27.UV Index HI alarm
Summary of Contents for SC089
Page 18: ...18 Figure 10 F...