VERS.2021.09.28 CS451_MAN_EN
19
5.2.2 Cutting the floor
You can now start the engine.
To make your cut,
Turn the depth hand wheel until the blade slightly touches the floor.
Open water valve to control the amount of water required for the type of blade, using 15 to 25l/min
for wet cutting and 1-2l/min for dry cutting (dust control). Check for minimum water level regularly
when using the water tank.
To lower blade into the cut, turn hand wheel clockwise. Each turn of the hand wheel will raise or
lower the blade by 10mm.
Once the required depth of cut is reached, push the machine forward with steady and gentle
pressure and follow the line with the cutting guides. The feed speed must be adjusted depending
on the material being cut, and depth of cut.
At the end of the cut, raise the blade out of the cut by turning the hand wheel anti-clockwise, shut-
off the water and switch off the engine.
