VERS. 04.12.2019
MAN CWM 216/254 EN
13
Bench mounting
There are 4 mounting holes (12) at each corner of the base (39) to facilitate bench mounting.
1. Place the miter saw over the workbench tabletop and mark four locations on top of the workbench that
correspond to the mounting hole positions.
2. Drill four mounting holes (Ø 11 mm) at the marked location of the workbench.
3. Place the miter saw on the workbench and align the mounting holes of the base with the drilled holes in
the workbench.
4. Firmly secure the miter saw to the bench surface with 4 bolts (not provided).
5. Carefully check the workbench after mounting to make sure that no movement can occur during use. If
any tipping, sliding, or other movement is noted, secure the workbench to the floor before operating.
Dust Extraction (fig G, H, I)
The product can be used with the dust collection bag (5) or an external dust extraction device.
Dust collection Bag
1. Attach the dust collection bag (5) to the dust extraction outlet (41) (Fig. G).
2. Pull the dust collection bag off to remove it from the appliance.
3. To empty the dust collection box, open the bag by pulling out the sealing slot (5a) (Fig. H).
External dust extraction device
Attach a proper dust extraction device, e.g. a suitable vacuum cleaner attachment (Ø 35 mm) to the dust
extraction outlet (41) (Fig. I).
Adjusting mitre angle (fig J, K)
1. Unlock the turntable locking handle (20) (Fig. J step 1).
2. Press the miter angle adjustment lever (21) downward and hold it in positon (Fig. J step 2).
3. Hold the turntable locking handle (20) and rotate the turntable (23) until the miter angle pointer (16a)
aligns with the desired angle on the miter scale (16) (Fig. J step 3). Release the miter angle adjustment
lever (21).
4. Press down to lock the turntable locking handle (20) (Fig. J step 4).
There are default adjustment positions for the miter angle at 0°, ±15°,
±22.5°, ±31.6° and ±45°.
The miter angle adjustment lever (21) can be locked at pressed position for
convenience.
1. Press the miter angle adjustment lever (21) downward and hold it in position (Fig.K step 1).
