VERS. 04.12.2019
MAN CWM 216/254 EN
16
Adjusting fence (fig P)
1. Unlock the fence locking lever (37) (step 1).
2. Slide the fence (13) to desired position (step 2).
3. Lock the fence locking lever (37) (step 3).
Ensure the saw blade does not interfere with the fence by conducting a
“dry run” with the cutting head set
to the required bevel and miter angle.
Adjusting work piece clamp (fig Q)
The work piece clamp (11) can be assembled on either side of the base. Use it to support work pieces of
different thickness by adjusting the height of the bracket (11d) and plate (11c).
Ensure the motor housing does not interfere with the clamp while operation with the cutting head set to the
required bevel and miter angle.
1. Loosen the locking knob (11a) (step 1) on the height adjustment pillar (11b) and adjust the bracket (11d)
to the desired height (step 2). Tighten the locking knob to secure the bracket (step 3).
2. Press the locking button (11e) and hold it in position (step 4). Adjust the height of the plate (11c) to the
surface of the work piece (step 5).
3. Rotate the height adjustment knob (11f) clockwise tightly to secure the work piece before operation (step
6).
Add a small scrap piece of thin plywood under the work piece clamp to avoid marking the work piece.
