Installing devices
* When operating your boiler for the first time, do not connect it initially to the engine. There may be
foreign matter in the boiler which could damage the engine. First flush out the boiler for about
ten minutes and drain hot water through valve port [B] before the initial operation .
(1) Place the boiler, burner, and steam engine on a flat surface. Then
fix the boiler and steam engine with wood screws. The burner
should be fixed by burner binding plates attached to the surface.
(2) Connect each section by rubber tubes and metal pipes referring
to the figure.
Preparation for operation
◆1.
Boiler
(3) Remove the overflow plug [A] and the safety valve [B]. Fill water through the port of [B] till water
comes out from the port of [A]. Placing a towel under [A] is recommended so as not to wet the
surrounding area.
(4) Then fix [A] and [B] back to their original position by fingers. Do not use wrench or pliers.
◆2.
(5) Keep both regulators closed until “Steam up” below is completed.
Burner
*Use only alcohol (methanol) for fuel. DO NOT use other fuels such as gasoline, paint thinner,
petroleum, etc.
(6) Close the needle valve[D] using the attached handle. If not closed, alcohol will drain out.
◆2.
(7) Remove the red safety valve [C] and fill tank with fuel to 250cc (8.5 oz) using a measuring cup and
a funnel. Do not exceed 250cc or the boiler may be damaged if the flame continues to burn after
there is no water left in the boiler.
(8) Then fix [C] back to the original position by fingers.
◆2.
(9) Place the pre-heating tray under the nozzle and fill alcohol to about 50% in the tray using the
attached squirter.
Steam engine
*Carefully read the instruction manual which comes with the T2GR steam engine before operation.
(10) Fill the oiler with steam oil (Blue liquid). Lubricate metal, crosshead, crankshaft, eccentric, etc. as
well as all revolution and movement sections with machine oil or 50 weight automobile engine
oil.
Preparation for operation is now completed.
Slide to insert
under the plates
Binding plates
fixed with
wood screws
- 2 -
Summary of Contents for B2G
Page 6: ...6...
