Instruction Manual
GB
2
Electrical requirements
Before inserting the plug into the wall socket
make sure that the voltage and the frequency
shown in the rating plate inside the appliance
corresponds to your electricity supply.
We recommend that this appliance be
connected to the mains supply via a suitably
switched and fused socket in a readily
accessible position.
Warning! This appliance must be earthed.
Repairs to electrical equipment should only
be performed by a qualified technician.
Incorrect repairs carried out by an unqualified
person carry risks that may have critical
consequences for the user of the appliance.
Transportation instructions
1.
The appliance should be transported only
in upright position. The packing as supplied
must be intact during transportation.
2.
If during the course of transport the
appliance, has been positioned horizontally,
it must not be operated for at least 4 hours, to
allow the system to settle.
3.
Failure to comply with the above instructions
could result in damage to the appliance, for
which the manufacturer will not be liable for.
4.
The appliance must be protected against
rain, moisture and other atmospheric
influences.
Important!
•
Do not attempt to sit or stand on top of your
appliance as it is not designed for such use.
You could injure yourself or damage the
appliance.
•
Make sure that the mains cable is not caught
under the appliance during and after moving,
as this could damage the cable.
•
Do not allow children to play with the
appliance or tamper with the controls.
Installation instructions
1.
Do not keep your appliance in a room where
the temperature is likely to fall below 10 º C
at night and/or especially in winter, as it is
designed to operate in ambient temperatures
b10 and +43 º C. At lower
temperatures the appliance may not operate,
resulting in a reduction in the storage life of
the food.
2.
Do not place the appliance near cookers
or radiators or in direct sunlight, as this will
cause extra strain on the appliance's functions.
If installed next to a source of heat or freezer,
maintain the following minimum side
clearances:
From Cookers 30 mm
From Radiators 300 mm
From Freezers 25 mm
3.
For efficient functioning, there should be a
gap of at least 5cm between the refrigerator
and the wall. To ensure this, attach the two
round buffers to be found inside the No Frost
appliance, as shown in the illustration
(Fig.2)
.
4.
The appliance should be positioned on a
smooth surface. The two front feet can be
adjusted as required.To ensure that your
appliance is standing upright adjust the two
front feet by turning clockwise or anti-clockwise,
