HS2/AS2 Series
5
6
·During installation of the battery, circuit breaker must be disconnected from the battery pack wiring.
2.2 Explanations of Symbols
Symbol
Description
Dangerous electrical voltage
This device is directly connected to public grid, thus all work to the battery shall only be carried out
by qualified personnel.
No open flames
Do not place or install near flammable or explosive materials.
Danger of hot surface
The components inside the battery will release a lot of heat during operation. Do not touch metal
plate housing during operating.
Attention
I
nstall the product out of reach of children
An error has occurred
Please go to Chapter 7
“
Troubleshooting
”
to remedy the error.
This device shall NOT be disposed of in residential waste
This battery module shall NOT be disposed of in residential waste
CE Mark
Equipment with the CE mark fulfills the requirements of the Low Voltage Directive and Electro
Magnetic Compatibility.
Recyclable
2.3 Battery Handling
Operate and use the battery properly according to user manual, any attempt to modify battery without the permission from SAJ will void the
limit warranty for the battery.
•
The battery must be installed at a suitable location with sufficient ventilation
•
Do not use the battery if it is defective, damaged or broken.
•
Only use the battery with compatible inverter.
•
Do not use the battery with other type of battery.
•
Make sure the battery is grounded prior to use.
•
Do not pull out any cables or open the battery enclosure when the battery is powered on.
•
Only use the battery as intended and designed.
2.4 Emergency Situation
Despite of its careful and professional protection design against any hazards, damage of the battery may still possible. If a small amount of
battery electrolyte is released due to a serious damage of the outer casing; or if the battery explodes due to not being treated timely after a fire
breaks out nearby, and leaks out poisonous gases such as carbon monoxide, carbon dioxide and etc., the following actions are recommended:
1
）
Eye contact: Rinse eyes with a large amount of running water and seek medical advice
2
）
Contact with skin: Wash the contacted area with soap thoroughly and seek medical advice
3
）
Inhalation: If you feel discomfort, dizziness or vomiting, seek medical advice immediately.
4
）
Use a FM-200 or Carbon Dioxide (CO2) fire extinguishers to extinguish the fire if there is a fire in the area where the battery pack is
installed. Wear a gas mask and avoid inhaling toxic gases and harmful substances produced by the fire.
5
）
Use an ABC fire extinguisher, if the fire is not caused by battery and not spread to it yet.
