- 23 -
•
First, ensure that you have taken photos with your camera. Press the shutter button a few times to take
some sample photos and try again. If you still get a no photos error, this indicates that the software was
not installed correctly or you may not meet the minimum system requirements.
•
System
Requirements:
At least a Pentium II 300 MHz, AMD Athlon 300 MHz, or a Celeron 400 MHz or higher, at least 128 MB
of RAM. Please note that the older AMD K6 processors will not work. More information about
determining your computer's specifications can be found in the General Computer Information section. If
you have determined that you have pictures in your camera and you meet the system requirements,
follow the steps below to reinstall the software.
•
Software
Re-installation:
1. First install the software. Click on Start, Settings, Control Panel and Add/Remove
programs. You will need to remove PhoTags Express. After removing it, restart your
computer. If your camera is connected, disconnect it.
2. Now reinstall the software. Insert the CD that came with your camera. It should
automatically run the installation.
3. Restart the computer.
4. Once your computer is back up, plug the camera into your computer's USB port.
5. Right-click on the "My Computer" icon. Select Properties.
If you are running Windows 2000 or XP: Click on hardware and then Device Manager.
