SAL DVR 200FHD Instruction Manual Download

Page: 5 / 37

Cameras without this feature often automatically and unnoticeably erase the important recording by the time it is needed. This function can be activated

and its sensitivity can be set in the

G-Sensor

menu item.

Depending on the vehicle and road conditions, adjust the sensitivity of the G-Sensor individually. In case of setting it too sensitive, a lot of recording cycles

may become protected against erasing unnecessarily and memory card gets full due to protected shots.

Irrespective of automatic locking, you can protect the current part of the recording manually at any time. Press

button for 3 seconds during the recording

and the cycle you are recording becomes protected against automatic deletion. Pressing the button again keeps this function clear and the „key” symbol

disappears from the screen. Protected recordings are stored in the EMERGENT folder within the DCIM folder.

Delete or protect the recordings

In Playback mode, use the stepper buttons to select the recording to be deleted or protected from deleting. Press the

MENU

button, then use the

UP /

DOWN

buttons to select the desired option, which you can confirm with the

button.

Delete:

Delete a defined one or all of the recordings.

Protect:

Lock or unlock all of the captures or unlocks.

Slide Show:

Slide Show mode allows you to scroll through a specified delay.

Of course, you can also delete or copy the recordings with a PC. If you have a card reader, you can also move the memory card to sort the recordings.

Settings in the MENU

This device has countless features that are forward-looking, novel. Please review the structure of the menu to find out what services are available and

adjust the functionality of the various functions according to your individual needs.

Depending on which mode the device is in, various setting options can be accessed by pressing the

MENU

button (3) one time. The second key press in

all three modes has the same

SETUP

menu for the general settings.

Use the DOWN / UP and OK buttons to scroll and select, to exit the MENU button.

Using of the rear-view camera

The backward camera allows you to observe the events behind the vehicle, not only during shunting, but also during transport. Placing inside the vehicle,

you can check the rear passenger or cargo space. The image of the front and rear camera are saved into separated directories. The two views can be

changed by pressing the button (

) or can be seen simultaneously - picture in picture mode .The camera is weather-resistant and has built-in 4 x LED

lighting. It is recommended by a qualified technician to securely fasten and connect the red (+ 12 V) and black (GND) wires to the reversing lamp with

the appropriate polarity. As a result, the reversing is detected by the device and the built-in LEDs of the rear camera illuminate under the maneuver. You

get the power from the main camera and connect the 4-pin,

∅

2,5 mm plug to the socket on the upper corner of the camera. After you connect it, the rear

view camera image is immediately displayed in the upper right corner of the screen. Press the

button or the reverse gear to display the full shutter

view and the colour guide lines to help parking.

When determining the position of the rear view camera take into consideration the protected, safe fixing is and to avoid turning the image on the screen.

IP44: protected against splashing water and penetration of >1 mm diameter bodies.

VIDEO MENU

Resolution

1080FHD / 720P / VGA

image quality

Loop recording

Off / 30 sec / 1 min / 2 min

recording stages

WDR

On-Off

increase sensitivity

Exposure