car digital videorecorder with rear camera
Before using the product for the first time, please read the instructions for use below and retain them for later reference. The original instructions were
written in the Hungarian language. After unpacking the product, make sure it has not been damaged during transport. Keep children away from the
packaging material, if it contains polybag or other hazardous components.This appliance may only be used by persons with impaired physical, sensory or
mental capabilities, or lacking in experience or knowledge, as well as children from the age of 8, if they are under supervision or have been given instruction
concerning use and they have understood the hazards associated with use. Children should not be allowed to play with the unit.Children may only clean
or perform user maintenance on the appliance under supervision.
• 2in1: forward and backward vision 2 cameras • Automatic switching of the display during rotation • Picture in Picture (PIP) display option •
Both camera pictures can be permanently recorded • Built-in 4 x LED lighting in the rear view camera • Parking assistant figure on the screen
• It can serve as evidence in case of accident• FULL HD resolution, high definition shots • Video camera or camera mode • Increased night-time
sensitivity, dual LED • Extremely wide angle of view to see everything • Extra quality 6 lens objective •Solid metal enclosure protects against
impact • Large 4 „(101 mm) LCD screen • WDR: Wide Range of Dynamics• LDWS: Lane Departure Warning System• FCWS: Forward Collision
Warning System • Continuous, cyclic recording; you do not miss anything • Auto start recording when motion is detected • Detects the collision
and locks the recording against erasing • Parking monitor: shooting at a collosion • Adjustable sensitivity G-SENSOR • Anti-shaking protection
for good image quality • Date, time and registration number on the recordings • microSD card, Class 10+, 8-128 GBmax. (not included) •
Accessories: suction cup holder, USB- miniUSB cable, ~3,3 m cigarette lighter connecting cable (12-24 V), ~5 metre rear view camera cable
Placement, installation
Screw the mount into the threaded hole on the top of the video camera. Tighten the grooved plastic nut found on the metal bolt in order to affix and stabilise
the video camera. Position the video camera as needed by loosening the large nut on the ball joint. Place the suction cup mount on the windshield of the
vehicle in a way that allows you to have a clear view of the road; the device must not obstruct the line of sight of the driver. After positioning the device as
desired, fix the position of the video camera by turning the large nut.
Place the device so that it does not come into contact with other objects. It may be practical to attach it next to the centre rearview mirror. The suction cup
and the glass must be cleaned before the installation. Only soapy water can be used! Remove the suction cup from the windscreen every month, or more
often in extreme heat or cold, otherwise it may lose its original properties. Clean it regularly before reinstalling! Do not leave the holder or the appliance in
the parking vehicle on its place. In case of particular sunshine or in a strong frost remove and put it in the glove compartment or trunk.
Power supply, connection
The device can be operated from the cigarette lighter socket on the vehicle, from 12-24 V DC. Use only the supplied connecting cable! Run the cable in
a circle, without injury, under the plastic frame around the windshield. It is recommended to run it above the inner rearview mirror under the edge of the
roof lining, then run it to the right under the plastic mouldings to the glove compartment, under that lead it further and connect it to the cigar lighting socket.
A USB- miniUSB cable (accessory) is required if you want to connect it to a computer with the purpose to copy the shots. If you have a memory card reader,
you can remove the card from the camera and manage the recordings with the card reader.
The built-in Li-Po battery does not operate the camera for continuous operation, but compensates for potential surges that may occur when starting or
stopping the vehicle, thus protecting the camera from malfunction The accumulator should be removed after service life and disassembled by a qualified
technician and treated as hazardous waste. If there is fluid leaking out of it, wear protective gloves and clean with a dry cloth. Do not open, burn or short-
circuit the accumulator. Non-rechargeable batteries should not be charged! Risk of explosion! Keep out of reach of children!
• The red LED on the upper right corner goes out when charging is completed.
• If the cigarette lighter plug indicator light is off, check the condition of the fuse in the plug.
• If the vehicle’s cigarette lighter socket is free of voltage after the ignition key is removed, not all extra functions are available.
• If you experience an operational problem or the product does not respond, reset the factory settings by pressing the RESET (9.) button (on the front,
under a miniUSB socket) with the documentary clip.
• Attention! If operated from a 24V supply, important information can be found on connecting the power supply in the chapter on the reversing camera.
Inserting a memory card (required for operation)
Turn off the device and insert the microSD (SDHC / TF) C memory card which has to be purchased separately. Do not force it, it can be slided in
one position only! The contacts should look back, in the direction of the screen.
It is recommended to use a minimum of 8 GB, but rather a 16-32 GB (max.128 GB) card. It is important to use at least CLASS10 marked one. Otherwise,
a warning text will appear on the screen after switching on. Slow memory card is not suitable for using in high definition cameras.
Before the first use, it is recommended to format the card in the video camera: 2 x MENU button / ▲▼/ FORMAT MENU
In addition to playing AVI and JPEG files, do not store other types of files on the
microSD
device as it may interfere with the operation. Use only quality
memory cards. Even these do not always work well, depending on their type or status. Their operation is not always guaranteed, which does not indicate
the fault of the unit.
Warning!
The manufacturer does not take responsibility for the loss or damage of data etc. even if the data etc. get lost during the use of the device. It is
recommended to make a copy of the data and tracks to your personal computer prior the use of the device.
Automatic start of recording
The device starts recording automatically when turned on. When connecting the power supply, the device starts automatically and thus starts recording.
Its operation may change depending on the vehicle based on whether the cigarette lighter socket remains powered after the ignition key is removed. In the
case of certain models, the socket remains powered at all times; in such vehicles, the video camera has to be turned on and off manually.
If the socket of the vehicle remains powered when parking, that is the removal of the ignition key, recording may continue. The driver must connect (starting
recording) and unplug the charger cable from the cigarette lighter socket, or by pressing briefly the OK (5.) button turning it on, by keep it pressed turning it
off. The turned on camera will start or stop recording by briefly pressing OK button. Turning on the device always causes the start of the recording and turns
on when the power is turned on. If the motion detection mode is activated in the menu, recording may start with motion.
