Salamander Designs SYNERGY SA/MD Quick Start Manual Download

Page: 4 / 4

Insert Back Panel

Drop the back panel into place, rounded edge up, matching pilot holes
with holes on the brackets and attach black screws from behind.

Drawer Face

Height Adjustment

Screw

Attaching Panels

Adjust Height and Add Trim Cover

Add Fixing Hooks to Drawer Face

REAR OF DRAWER FACE

NOTE:
The two fixing hooks that attach to
the front panel are different. Each
Bracket is marked “R” or “L”.

Adjustment screws on the fixing hook should face outside of the drawer box.

Tighten Bracket

with this Screw

Slip the bracket onto the drawer sides. Tighten inset screw to tighten clamp

bracket to drawer side.

Note: To adust drawer height, turn outter screw to left or right.

Apply trim cover to bracket.

Summary of Contents for SYNERGY SA/MD

Page 1: ...al Drawer Slides Metal Drawer Slides 1 Bottom Panel 200 640 1 Drawer Back 200 650 2 Drawer Brackets 300 640 6 C S Rivets 6 Backup Washers Drawer Spacer Tool Use the Spacer Tool included with base unit...

Page 2: ...al Any damage incurred in a shipment not in original packaging shall be the responsibility of the owner Warranty repairs will be returned prepaid via UPS within the continental U S A only 1 Installing...

Page 3: ...tch the bracket holes with the pilot holes and attach six black screws from bottom 4 A Place the low heads in the 2 holes of each drawer slide and attach loosely B Insert the weld nuts into the channe...

Page 4: ...d Fixing Hooks to Drawer Face 6 REAR OF DRAWER FACE NOTE The two fixing hooks that attach to the front panel are different Each Bracket is marked R or L Adjustment screws on the fixing hook should fac...