3 – Assembly
3.1
The stove is supplied with the flue collar inside the firebox. To fit the collar to the top of the
stove, you will need to remove the baffle and the side fire bricks. To do this, use one hand to
hold the baffle up before removing the side bricks -
please take care as the baffle is
heavy
. With the other hand, lift one of the side bricks up and lever it out from the bottom.
Do the same for the other side brick. You will then need to gently lower and rotate the baffle
so that it can be removed. Fit the flue collar to the top of the stove, and tighten it in place
with the screws provided. The collar can be fitted to the rear of the stove in the same way.
Remember to re-insert the baffle and the side fire bricks before using the stove.
Take extreme care not to over-tighten the screws for the flue collar. The screws should
ONLY
be
finger-tight, else you will risk breaking the lugs.
If the installation requires the flue to exit from the rear of the stove, swap the collar for the blanking
plate on the back.
3.2
Gently lay the stove on its side. Attach one leg to
each corner of the base, using the bolts and
washers provided. Next, carefully lift the stove
upright to rest on its feet.
3.3
Check that the grate and grate centre are located
correctly. The grate should sit horizontally inside
the stove. Check that the riddling mechanism
operates and moves freely.
4 – Components
WARNING
Page 4 of 22
Page 5 of 22
