P a g e
|
5
12-86-0000 KEYRING TRANSMITTER
Product Manual
Sea Air and Land Communications Ltd, 10 Vanadium Place, Addington, Christchurch 8024, New Zealand
February 2019
Programming
In order to program the 12-86-0000 programming software should be downloaded from the
Salcom website (www.salcom.co.nz).
A Salcom 12-47 programming lead is required to
program the 12-86 transmitters (same lead used to
program the 11-85 transmitters), together with a 4-pin
header. This may be purchased separately. The 12-
47 programming lead requires the availability of a PC
with a serial port, running windows XP.
Connect the 12-47 as shown below, with the dot on
the 12-47 socket (circled in yellow in the photograph
below) towards the center of the PCB (mating with
the square pad).
The 12-86 Programming Software allows the transmitter frequency and button messages to be
set.
1.
Press “Connect”. The red LED will light, as a message is transmitted - this occurs when
entering program mode. After the message has been sent, the green LED will light for
approximately 1 second (visible on same side as buttons). The status at the bottom of the
12-86 configuration tool will indicate if successfully connected.
2.
Press “Read”. The current configuration is read from the 12-86.
3.
Make any required changes.
4.
Press the “Program” button.
5.
Press “Disconnect”, then remove programming lead.
General Configuration
Button Messages:
Select the button to view the message, CapCode and beep level assigned to
that button. New button settings can be entered, but will not be written until the program button
is pressed. The program button only needs to be pressed after all button details have been
populated.
Frequency:
The transmit frequency between 440 and 470MHz to be set using 25kHz channel
spacing.
