20
Smarty 3X P
www.salda.lt
• Easy user‘s menu for sound, temperature, stand-by mode and CO
2
level settings;
• Fast button for setting maximum speed;
• Display of set supply air temperature;
• Selected speed LED indication;
• “Child safety feature” - locks the controller.
Description of elements
B1
On/Off
B2
Fan speed selection
B3
Temperature selection
B4
Increase
B5
Maximum fan speed for limited time
(boost)
B6
Decrease
S1
Segment display
L4-L7
Fan speed indications
Elements
Coomand
Action
Indication
B1
L1
Switch on
Press down for 2 seconds B1
L1 lights on.
B1
L1
Switch off
Press down for 2 seconds B1
L1 lights off.
L1
Switch off
Press any button.
L1 flashes slowly in sleep mode.
B2 B4 B6
L2
Set fan speed
Touch B2.
L2 lights on. Speed is adjusted by touching elements B4 and B6
B3 B4 B6
L3
Set temperature
Touch B3.
L3 lights on. Temperature is adjusted by touching elements B4 and B6
B4 B6
L4-L7
Change value of selected set-
ting
Increase by touching B4, de-
crease by touching B6
Numbers change in the segment display. L4, L5, L6, L7 shows selected fan speed.
B4 B5 B6
L2
Switch on/off the intensive
ventilation (boost)
2 sekundes palaikyti B5.
L2 flashes. Remaining time in seconds is shown in the segment display (for values
above 600s, time is shown in minutes). Time is adjusted (during operation of the func-
tion) by touching B4 and B6.
Maximum BOOST running time: 180m. (3h)
B4 B6
L4-L7
Review and cancel alarms
For canceling, press down B2
and B3 for 3 seconds.
In case of alarms, L4, L5, L6, L7 flash and alarm code is shown in the segment dis-
play (A.01, A.02 etc.). You can review alarm list by using elements B4 and B6. After
alarm is canceled, controller returns to initial state.
NOTE:
It is strongly prohibited to
cancel the alarm without removal of its cause. This must be performed by service
representatives or staff.
L2-L7
CO2 blow off
L2, L3 and L7 flash, L4, L5, L6 light on.
B2 B3 B5
On/off
“Child safety feature”
Press down B3, B2 and B5 for
2 seconds.
Non active elements B1, B4 and B6. After pressing unavailable button, segment
display shows “−−−”
Selecting 4 pre-set speeds:
• 0 speed – stand-by mode;
• 1 speed – building protection mode;
• 2 speed – economic mode;
• 3 speed – comfort mode.
Each mode (except stand-by) has its own temperature setting. The temperature setting is made by selecting the desired mode. In economic and
standby mode temperature back-up can be turned off. Reducing temperature setting until the segment display shows the symbol “-.-” meaning that
temperature back-up is turned off in the selected mode. It is impossible to turn off temperature back-up in comfort mode.
BOOST function period is being read form control board during the activation moment of the function. After manual change of the time with the control
panel, the left time is being set automatically in the control board.