EN |
17
SMARTY XV v2020.2
6.8. CONTROL BOARD MAINTENANCE
- Unscrew the front bolt securing the control board holder to the unit casing.
- Withdraw the automation through the front part.
- Disconnect the connectors from the control board.
- The connectors are marked according to connection location. Thus during automation reassembly please observe the marking of the connection
location of connectors and controller. If the marking on the controller terminals is not visible follow the PCB information provided in this passport
(see miniMCB description: Fig. 2 and Fig. 3):
1.
2.
3.
6.9. SMARTY 4XV SWITCHING POWER SUPPLY
MAINTENANCE
• Unscrew screw at the front side;
• After loosening power supply, lift it up in order to disconnect connector below. (2-3).
• Power supply is under the protection cover. Please remove the cover in order to change it (4-5). Then release power supply from the base (6-7).
• Perform assembly in the reverse order.
• Connectors are marked according connection place, therefore, please, pay attention to the marking.
1.
2.
3.
4.
5.
6.
7.
Summary of Contents for SMARTY XV Series
