24
| EN
SMARTY XV v2020.2
Automatic and manual protection shall be connected to controllers X5 connector if the electric heater/pre-heater is equipped with these connection
terminals. Otherwise jumpers are installed on X5 connector protection inputs.
Since a pre-heater is to be connected according to the factory settings, settings should be changed in the environment of the MB-Gateway WEB
application service or on the ST-SA-Control panel.
Settings in the environment of the MB-Gateway WEB application service
Change the settings as follows:
• Service password 4444;
• Service -> Heaters -> Heater and pre-heater position;
• Select either the heater or pre-heater to be switched on MiniMCB basic.
1
With the Stouch control panel, it is impossible to change the settings
• Service -> Digital inputs -> Heaters protection inputs
Set the manual and automated protection statuses of the heater or pre-heater – should be NC by default.
Summary of Contents for SMARTY XV Series
