14
1.
Figure 1 is an overview of the
routing of the wire harness.
2.
The ground and the positive
lead are at one end of the
harness. The positive lead (red
wire with ring terminal) gets
attached to the fuse box (Figure
2). Figure 3 shows a close up.
Use a ¼” drive ratchet with a 10
mm socket and install the ring
terminal.
3.
The ground (black wire with
ring terminal) will be connected
next to the fuse box. Use the 10
mm socket with, ¼ drive with
an 8” extension to fasten the
ring terminal down. See figure
4. You will have to move the
plastic tubing out of the way.
Figure 2
Figure 3
Fasten ground under this screw
