12
Figure 24
Figure 23
Tighten
nut in
here
26.
Place one washer (00-9004-
C11804*) and one hex nut (00-
9003-C11803*; use red Loctite)
over each (2 total) of the furthest
inboard studs (those that are not
easily visible) and tighten with an
angled ratcheting 7/16” wrench
(Figure 23 is a close-up of Figure
22; Figure 24 is a view of the inside
of the deck lid, and shows the nut
on the studs).
Torque the nuts to 5
lb-ft.
27.
Remove the rope from the deck lid.
28.
Using the oval rubber plug (00-
9009-C11813*) cover each of the
two holes drilled out with the
electric dremel in step 12. (Figures
11,12)
29.
Check to make sure you have
placed a nut on every stud on the
wing – four per side, or eight total
(four regular hex nuts and four
acorn hex nuts). Make sure all nuts
have been tightened securely and
torqued.
Figure 22
Summary of Contents for 10-8002-C11998B
Page 2: ...2...
