9
14.
Using paint thinner, clean around the
bottom side of the wing in the raised
portion around the studs (clean the area
indicated by the dotted line in Figure
13).
15.
Apply automotive adhesion promoter
(3M# 06396) around the base of the
studs; follow the dotted line in Figure
13.
16.
Cut sections of tape to form a perimeter
around the studs. Do NOT allow the
tape to go over the edge of the elevated
platform through which the studs
protrude – the idea is to position the
tape so it is not visible when the wing
is installed. Cut semi-circles in the tape
where necessary to accommodate the
studs (Figure 13). Place the tape around
the studs (follow the dotted line in
Figure 13). Press the tape FIRMLY
onto the wing.
17.
emove the backing from the bumpers
(00-9009-C12058*) and place one
under the front of each wing tip.
(Figures 14, 15)
Figure 12
7/8”
Figure 13
studs
Passenger side
Figure 14
5/8”
Figure 15
Summary of Contents for 10-8002-C11998B
Page 2: ...2...
