FT TRUCK MT
30
Operation Procedure
¾
BOOM SWITCHES = “OFF”
¾
CONTROL CONSOLE = “POWER – ON”
¾
MODE = “OPERATE”
¾
DISPLAY TO % RATE – SHOULD BE AT 100%
¾
DISPLAY TO – “APPLICATION RATE” – USE “ INC.” OR “DEC.” SWITCH TO ENTER
MATERIAL (IN LBS.) TO BE APPLIED PER ACRE
¾
MODE = “SET-UP”
¾
DISPLAY AT APPLICATION RATE (ALREADY ON) – USE “INC.” OR “DEC.” TO SET
PRODUCT DENSITY WEIGHT (LBS. PER CUBIC FOOT)
¾
DISPLAY TO “TOTAL APPLIED” - BE SURE CONSTANT NUMBER CORRESPONDS TO
SET-UP
¾
MODE = “OPERATE”
¾
DISPLAY = “IMP. WIDTH”
¾
MASTER SWITCH TO “ON” POSITION – SCREEN WILL SHOW SELECTED SPREAD
SWATH - IF NOT WHAT IS DESIRED, TURN MODE BACK TO SET-UP
¾
BOOM SWITCHES = “OFF”
¾
ENTER DESIRED SPREAD SWATH IN INCHES INTO BOOM #1 – ALLOW TO CYCLE
THRU BOOMS #2 - #9 MAKING SURE ALL ARE SET ON “0” – NOW RETURN TO
“OPERATE” MODE
¾
BOOM SWITCHES = “ON” - DISPLAY SHOULD NOW READ IN “NO. OF FT.” SPREAD
SWATH DESIRED
¾
BOOM SWITCHES = “OFF”
¾
DISPLAY = “APPLICATION RATE”
¾
TO BEGIN SPREADING – SET “G.S.O.” SWITCH TO “AUTOMATIC”
¾
POWER = “ON”
¾
MASTER SWITCH = “ON”
APPENDIX
