12
INSTALLATION
5. Installation
5.1. Inspecting the Equipment
Inspect the UPS upon receipt. If the UPS has been dam-
aged during shipment, keep the box and packing material
for the carrier. Notify the carrier and dealer immediately.
5.2. Placement
This UPS should be installed indoors with adequate airflow
and free of contamination. Locate it in a clean and indoor
environment, free from moisture, flammable liquids, and
direct sunlight. Maintain a minimum clearance of 4 inches
(100mm); an ambient temperature range must be 0°C to
40°C (32°F to 104°F), and operating humidity range must
be 20% to 80% relative humidity (non-condensing)..
The long term uses at ambient temperature in
higher than 25°C which should reduce battery life.
In addition, place the UPS unit away from the monitor at
least 20cm. to avoid interference.
5.3. Charging
This UPS is shipped from the factory with its internal battery
fully charged; however, some charge may be lost during
shipping. The battery should be recharged prior to use.
Plug the UPS into an appropriate power supply and allow
the UPS to charge at least 4 hours.
5.3.1. Load connection
Connect one load-related device to each of the power re-
ceptacles supplied at the rear of the UPS.
5.4. Modem / Phoneline
Connection
Plug incoming telephone line into the “In” socket at the back
of the UPS. Use on telephone line cable and plug one end
of the telephone line cable to the “Out” socket at the back
of the UPS. Plug the other end to the modem input socket.
5.5. DC Start function
DC Start Function enables UPS to be started up when AC
utility power is not available and battery is full charged. Just
simply press the On/Off switch to turn on the UPS.
5.6. Turn On/Off
To turn on/off the UPS, you should press the on/off switch
three seconds at least.
5.7. UPS Setup
All models series are designed for tower and rack purpose.
They can be installed as a 19 inch equipment rack, and
3000 VA can be placed in a tower (with optional stand) as
well. Please follow the instruction for Tower Setup or Rack-
Mount Setup.
5.7.1. Tower Setup
This series can be placed in horizontally and vertically.
3000 VA model is designed in a rack itself. As a tower, it is
provided with the optional UPS stand to stabilize the UPS
when the UPS is positioned in vertically. The UPS stand
must be attached to the bottom of the tower.
5.7.1.1. 750 / 1000 VA models
Fig. 15.
Front view 1500 / 2000 VA models
USER'S MANUAL
