20
SALICRU
noting the new date of recharge of the batteries in the
field of the label - see Fig. 17.
Units that are part of a parallel system will be treated
as individual equipment for battery recharging and
therefore no additional connection is required.
5.1.3. Unpacking.
•
The packaging of the equipment consists of wooden pallet,
carton or wood enclosure according to cases, polystyrene
foamed corners [EPS] or polyethylene foam [EPE], polyeth-
ylene sheath and strap, all recyclable materials; so if you
are going to get rid of them you must do it according to the
laws in force. We recommend storing the packaging in case
it should be used in the future.
Fig. 18.
Example of transfer of packed ADAPT X with pallet
jack.
Fig. 19.
Example of removal of carton enclosure.
•
To unpack the equipment, cut the straps of the carton en-
closure and remove it as if it were a cover (see Fig. 18 and
19) or disassemble it with the necessary tools if the casing
is made of wood; remove the corners and the plastic sheath
and the UPS will be naked on the pallet. The Figs. 18 to 20
shows the 6-slot subrack as an example.
Fixing
screws
Fixing angle
Fig. 20.
Equipment unpacked as an example on pallet.
•
Remove the screws and/or the fixing angles, indicated in
Fig. 20.
•
With the help of one or two people on each side,
download it from the wooden pallet. Pay special at-
tention to the subrack with 6 slots, as incorporating castors
could fall from the pallet and cause an accident, beyond the
material damage itself.
5.1.4. Transport to the site.
•
If the receiving area is far from the installation site, it is
recommended to move the ADAPT X using a pallet truck or
other suitable means of transport, assessing the distance
between the two points, the weight of the unit, the charac-
teristics of the passageway and site (floor type, floor resist-
ance kg/m
2
,... ).
•
The 6-slot subracks incorporate four castors (with mechan-
ical locking), so it is easy to move it to the installation site
once unpacked.
•
However, when the distance is considerable, it is recom-
mended to move the packaged equipment to the imme-
diate vicinity of the installation site and its subsequent
unpacking.
5.2. LOCATION.
5.2.1. Location of the ADAPT X.
•
The following premises will be taken into account when
locating a modular UPS ADAPT X, as this is a safety equip-
ment in terms of power and not to prevent or invalidate its
own role:
Not suitable for outdoor installation. Protection degree
by default IP20.
The location will be in a ventilated room, controlled
temperature and humidity to keep the equipment in the
environmental parameters within the specified oper-
ating range. The cooling capacity of the air conditioner
will be selected according to the heat losses of the UPS
and other equipment that can cohabit in the same room.
The room will have adequate filters to prevent dusty
or lint-free environments from contaminating the
