- 43 -
8.- MISE EN MARCHE ET ARRÊT.
8.1.- Contrôles avant la mise en marche.
• Vérifier soigneusement que toutes les connexions ont été réalisées correctement et qu’elles sont suffisamment serrées,
suivant l’étiquetage de l’appareil et les instructions du chapitre 7.
• En connectant la fiche d’entrée
(C1)
à une prise de courant de réseau d’AC, l’écran
(LCD)
s’allume avec les ventilateurs et le
chargeur de batteries en marche.
•
Procéder dans l’ordre indiqué pour la mise en marche aussi bien que pour l’arrêt de l’
ASI
.
8.2.- Mise en marche.
•
Avant d’utiliser l’
ASI
pour la première fois ou après un arrêt prolongé de plus de 6 mois, il faut recharger les batteries
pendant au moins 4 heures. Attendre de l’avoir fait pour continuer la procédure de mise en marche.
• Enfoncer pendant au moins 3 secondes le bouton
(ON/OFF)
du panneau de contrôle, le voyant
( )
s’allumera. Le système
réalisera un autotest interne; cela fait, l’inverseur de l’
ASI
se mettra en marche et fournira une tension de sortie.
N’importe quelle anomalie du réseau sera absorbée par l’appareil.
Pendant la mise en marche, l’écran
(LCD)
affiche le message «EN ATTENTE» et quand l’appareil fournit une tension de sortie,
le voyant
(
)
s’allume et l’écran
(LCD)
affiche le message «EN MARCHE».
• Mettre en marche les charges critiques à alimenter.
8.3.- Arrêt quotidien de l’ASI, arrêt de l’«inverseur».
• Arrêter les charges et enfoncer le bouton
(ON/OFF)
pendant au moins 3 secondes, l’inverseur s’arrêtera.
• L’écran
(LCD)
affichera «EXTINCTION» pendant quelques secondes, puis il restera simplement allumé, avec les ventilateurs et
le chargeur en marche.
8.4.- Démarrage à froid, sans réseau commercial.
• Le processus de mise en marche à froid (sans réseau commercial) est le même que celui de mise en marche normal, sauf en
ce qui concerne l’absence de réseau, les indications optiques du panneau de contrôle, les indications acoustiques et les
indications d’écran
(LCD)
«SUR BATTERIES».
•
L’appareil étant bloqué par le logiciel contre la mise en marche accidentelle pendant le transport, le démarrage à froid
n’est pas possible à la réception de l’appareil.
Le brancher au réseau et le mettre en marche pour la première fois en suivant les indications du paragraphe 8.2.
Summary of Contents for SLC Link Series
