14
SALICRU
Fig. 3.
Unpacking sequence
•
The device is attached to the wooden pallet at the factory
by means of an L-shaped metal piece (stabilising brackets)
located on each side.
•
Remove the screws that join the piece to the pallet and
device [see Fig. 4 and 5].
•
Before removing the device, withdraw the stabilising
brackets so that they do not hinder the process and
bend when impacting against the wooden ramp, which can
cause damage to the structure of the device enclosure.
•
Position the ramp as shown in Figure 3 and remove the
device from the pallet.
Fig. 4.
Fig. 5.
5.1.4. Transport to the site.
•
All devices have four wheels (with mechanical locking), so
it is easy to move it to the installation site once unpacked.
If the reception area is far from the installation site, how-
ever, it is recommended to transport the UPS by means of a
pallet jack or the most appropriate method considering the
distance between the two points.
If the distance is considerable, it is recommended to trans-
port the device in its packaging to the installation site and
then unpack it.
5.1.5. Siting, immobilising and considerations.
5.1.5.1. Siting for single devices.
•
Fig. 6 shows, by way of example, typical cases depending
on the model. That which consists of a single enclosure
(UPS with batteries inside) and that with the UPS with bat-
teries in a separate enclosure or extended backup.
For correct ventilation of the device, it is necessary to
leave its surroundings free from obstructions. Respect
the minimum distances indicated in Tab. 1 of section
1.2.1 of document EK266*08 (Safety instructions), in
which the values for distances A, B, C and D are indi-
cated depending on the power of each device.
For the battery enclosures, maintain similar distances
to those for the UPS that makes up the system.
It is recommended to leave an additional 75 cm free on
the sides to enable maintenance and repair interven-
tions
(T.S.S.)
or the necessary clearance of the connec-
tion cables to facilitate the forward movement of the
device.
For extended backups with more than one enclosure, it is
recommended to place one on each side of the device and,
in the case of a greater number of battery enclosures, re-
peat the same sequence.
