18
8 to 10 kVA models, the connection with battery modules for
extended back up time, it is done through a connector lo-
cated in the rear side of the equipment (see figure 11).
Ŗ
All the instructions relating to connections will detailed later
on, less those ones regarding the battery connection. There-
fore, this section will only describe the works linked with the
assembling.
4.2.5.1. Rotation of control panel with LCD.
90º
"A"
"B"
"C"
Fig. 5.
Rotation of control panel with LCD over the beautiful
front plastic cover.
Ŗ
To make easier the message reading when the equipment is
vertically installed, it is advisable to rotate 90º clockwise the
control panel with LCD (see figure 4).
Ŗ
Also, it is advised to rotate the control panel, if any tower type
equipment requires to be assembled as rack. Consider that the
rotation of the control panel will be counter clockwise.
Ŗ
Proceed as follows:
Pull from the control panel with LCD out "A", to free the
fixing clips and take it out.
Rotate it 90º on clockwise "B" and insert it again into the
beautiful front cover till click it "C".
4.2.5.2. Taking out or putting the beautiful front
cover.
Ŗ
To take out the beautiful front cover, proceed as follows (see
figure 6):
Take out the control panel "A" (see section 4.2.5.1) and
remove the fixing screw "B" of the beautiful front door lo-
cated below the first one and put the own control panel
back.
Remove the two fixing screws "C" from beautiful plastic
front cover.
Move the front cover to "D" direction, by applying a hard
and moderated knock on its side (side without screws), to
free the trim entered into the metallic frame.
The front is free, but still joint to the equipment through
the connection bus of the control panel.
Ŗ
To put the beautiful front cover back, proceed in the reverse
way to its removing.
"A"
"C"
"B"
"D"
"D"
Fig. 6.
Taking out the beautiful front cover.
4.2.5.3. Vertical -tower type-assembling.
Ŗ
Rotate the control panel according to section 4.2.5.1.
Ŗ
In equipments up to 3 kVA, take the 4 plastic pieces "A" in
angle shape supplied with the equipment and joint them two
by two till obtain two supports or stabilizers "B".
Ŗ
For equipments up to 3 kVA.
Put the UPS vertical between the two stabilizers supports
"B" (see figure 7).
For equipments of higher power.
Put the equipment vertical and fix the two metallic sup-
ports, one at each side, by means of the supplied screws
(models 4 to 6 KVA).
For equipment of 8 to 10 kVA, put the equipment vertical.
There are not supports or stabilizers.
USER MANUAL
