10
SALICRU
5. INSTALLATION .
•
Read and respect the Safety Information, described
in section 2 of this document. To obviate some of
the indications stated in it, can cause a serious or very se-
rious injuries to persons in direct contact or in the vicinity,
as well as breakdowns in the equipment and/or loads con-
nected to itself.
•
Check that all data of the nameplate are the required ones
by the installation.
•
Once the equipment is unpacked and before proceeding, in-
spect and check it in order to see that everything is the right
conditions. Otherwise contact with the dealer.
•
Depending on the morphology and sector or oper-
ating environment, there could be some connection
and use restrictions of the equipment:
Due to its connection.
–
Equipments with power cord with plug and outlets
(not hard-wired).
It can be connected by personnel with no specific
training, so in general the same end-user in home
environments can do it.
Due to its use.
–
Equipments with no terminal strip, in general the
ones destined for home environments and in a
lesser extent in shops and industrial or other sec-
tors.
Personnel with no specific training can use
them, just with the simple help of the user's
manual
.
•
Any connection of the equipment including the com-
munication one (interface), will be done with all the
switches turned off and with no voltage present (power
supply switch of the UPS to «Off»).
•
Do not forget that the UPS is an energy generator, so
the end-user has to take the necessary precautions
against direct or indirect contacts.
5.1. LOCATION AND STORAGE CONDITIONS.
•
Install the UPS in a protected area ad free of excessive hu-
midity and with a suitable ventilation.
•
Locate the UPS 20cm far from other units in order to avoid
interferences.
•
Do not start up the equipment where the temperature and
humidity exceed the allowed limits(see the technical speci-
fications).
20 cm
20 cm
5.2. CONNECTING THE EQUIPMENT TO MAINS FOR
FIRST TIME OR AFTER TWO MONTHS OF NO USE.
•
Plug in mains power plug 1 to an AC outlet.
In those models with IEC inlet , a cable is supplied together
with the equipment. Insert the IEC connector into its base
2
and the mains power plug of the other end to the AC outlet.
•
To get better results, charge the batteries
for 4 hours at least, before using it for
first time or after a period of time longer
than two months of no use.
Otherwise, the reaction of the SPS.ONE
can be unsatisfactory in case of black-
outs during the first hours of operation.
Becuase its capacity of response during
unexpected blackouts of the AC mains is
conditioned to the stored energy in the
batteries.
•
The battery is charged by plugging the equipment to mains
only.
5.3. CONNECTION OF LOADS.
•
Plug the loads in the outlets
3
, located in the rear side of
the unit.
•
Do not connect a laser printer or
scanner to the UPS. They can
damage the unit and/or deplete the en-
ergy stored in the batteries, which is re-
served for a more critical and sensitive
loads.
5.4. CONNECTION OF MODEM/PHONE LINE.
Connect the modem/phone line to the RJ 5 connector at the
back of the UPS. Connect the modem/phone cable to the RJ 6
connector of the equipment.
5.5. CONNECTION OF COMMUNICATION CABLE.
•
To make possible unattended UPS start up and shutdown
and the monitoring of its status, connect one of the ends of
the communication cable to connector
4
of the USB port of
the SPS.ONE and the other end to the communication port
of the PC.