salmson Claris home, Installation And Starting Instructions

13

English

removed whilst the product is in operation.

•  Leakages (e.g. from the shaft seals) of hazardous 

fluids (which are explosive, toxic or hot) must be 
led away so that no danger to persons or to the 
environment arises. 
National statutory provisions are to be complied 
with.

   2.6  Safety instructions for installation and mainte-

nance work
The operator must ensure that all maintenance 
and installation work is carried out by author-
ised and qualified personnel, who are sufficiently 
informed from their own detailed study of the 
installation and operating instructions. Work on 
the product/unit must only be carried out when 
at a standstill. It is mandatory that the proce-
dure described in the installation and operating 
instructions for shutting down the product/unit 
be complied with.
Immediately on conclusion of the work, all safety 
and protective devices must be put back in posi-
tion and/or recommissioned.

   2.7  Unauthorised modification and manufacture of 

spare parts
Unauthorised modification and manufacture of 
spare parts will impair the safety of the product/
personnel and will make void the manufacturer’s 
declarations regarding safety.
Modifications to the product are only permissible 
after consultation with the manufacturer.
Original spare parts and accessories authorised by 
the manufacturer ensure safety. The use of other 
parts will absolve us of liability for consequential 
events.

  2.8  Improper use

The operating safety of the supplied product is 
only guaranteed for conventional use in accord-
ance with Section 4 of the installation and oper-
ating instructions.
The limit values must on no account fall under 
or exceed those specified in the catalogue/data 
sheet.

3. Transport and intermediate storage

When you receive the equipment, check that it 
has not been damaged during transport. If you 
notice a fault, take all necessary action with the 
carrier within the time allowed.

CAUTION! Storage environment may cause 

damage. 
If the equipment is to be installed at a later date, 
store it in a dry place and protect it from impacts 
and any external stresses (humidity, frost etc.).
Temperature range for transport and storage: 
-30°C to +60°C

Handle the pump with care so as not to damage 
the product before installation.

4. Application

Pumps designed for pumping and pressure 
boosting of clean water or lightly contaminated 
water in the residential and agricultural sectors 
and other sectors.
Water supply from a well, cistern, other static 
water supply, municipal water mains etc. for the 
purposes of irrigation, sprinkling, pressure boost-
ing etc…

DANGER! Risk of explosion! 
Do not use this pump to convey flammable or 
explosive liquids.

5. Technical data

  5.1  Data table

  5.2  Included in delivery

•  Multistage horizontal pump
•  Male electrical connector
•  2 connections (depending on model)
•  2 gaskets (depending on model)
•  Operating manual

Hydraulic data

Maximum operating pressure

8 bar (8 x 10

5

 Pa)

Minimum suction pressure

0,2 bar (0,2 x 10

5

 Pa)

Maximum suction pressure

3 bar (3 x 10

5

 Pa)

Maximum altitude

1000 m

Geodetic suction head

8 m max.

DN of suction connection

1“

DN of pressure connection

1“

Temperature range

Fluid temperature range

+5°C to +40°C

Ambient temperature

max. +40 °C

Electrical data

Motor protection rating

IP X4

Insulation class

155

Frequency

See pump cladding

Voltage: 

Other

Max. sound level

63 dB(A)

Salmson 09/2016