1
•
Connect to power supply.
•
Switch ON the Main Power Switch [12].
•
With “00” visible in the Time Display, the machine is ready for
operation.
2
•
Use buttons [2] and [3] to set the appropriate time:
(Each time button
[2] is pressed, it adds one minute. Each time button [3] is pressed, it
will add ten minutes.)
•
Use buttons: [4] [5] [6] [7] and [8] to set an appropriate temperature
for each Heater – each time a heater button is pressed it will go to
the next temperature setting:
3
•
Press the
O₃
button, [10] when
O₃
is required. Press again to stop.
•
Press the COOL button, [11] if cooling is required. Press again to
stop.
4
•
Press the main START/STOP button, [11] to begin operation.
•
Press the main START/STOP button, [11] again to halt operation.
Important:
• Always keep client’s hair and head at least 4 – 8 inches (10 – 20 cm) from
Heater Lamps.
• Always keep the client’s head centered between lamps.
• Always rest equipment for at least 15 minutes during each hour of use.
Operation
+1
+10
On
Off
Timer
Time Setting
Left
Cool
O3
Right
Time Setting
Start/Stop
28
1. Time Display/Cooling Display.
2. Press once to increase time by one minute.
3. Press once to increase time by ten minutes.
Temperature setting buttons:
4. Left heater
5. Right heater
6. Top heater
7. Bottom heater
8. Back heater
9. Cooling
10. O₃
11. Start/Stop
12. Power Switch
3.
2.
6.
9.
11.
4.
7.
8.
5.
10.
1.
12.
LED’s:
None
1
2
3
4
Temp:
None
122°F
144°F
163°F
185°F
Note:
The temperature may vary slightly depending on the time in use.
Control Panel
