Maintenance
Suction
It is important to keep the suction screen from any blockage or obstructions at all times, due to they may reduce the whirlpool
action and may cause damage to the pump.
To Clean:
Take off suction screen by removing two screws and clean with soft brush while immersed in disinfectant.
After each customer (Standard Jet System Users)
1.
Drain completely and remove residual debris from basin.
2.
Clean the surfaces and basin with mild detergent, rinse with fresh water.
3.
Disinfect with an EPA-registered disinfectant with bactericidal, Fungicidal, and virucidal activity used according to MFG
recommendation.
4.
Wipe the pedicure spa dry with clean cloth.
After each customer (Standard System Users)
1.
Drain completely and remove debris from the basin.
2.
Spray disinfectant on the basin and flush out with fresh water.
3.
Remove (
see clean jet system
) and immerse jet cover into disinfectant for 5 minutes.
4.
Placing jet cover (
see clean jet system
) and please follow direction.
Daily ( Standard Users & Clean Jet System Users)
1.
Remove the intake suction screen. All debris trapped on or behind the screen must be removed. The Suction screen and the
suction inlet must be free of debris.
2.
Before placing the screen, The screen must be immersed with EPA - Registered disinfectant.
3.
Flush out the whirlpool with low foaming detergent and warm water for 10 minutes.
4.
With fresh water, EPA - registered cleanser for 5 minutes.
5.
Rinse with fresh water.
Manufacturer requires that the pedicure spa be thoroughly cleaned at the end of the day in following manner.
Weekly ( Standard users & Pipless System users)
1.
Fill the basin Hot water up to its level.
2.
Add 3 to 4 table spoons of a low foaming agent and 1 to 2 table spoon of powder bleach.
3.
Run whirlpool for 5 minutes.
4.
Stop whirlpool and sit for 5 to 7 minutes.
5.
Open Air control and whirlpool for 5 minutes.
6.
Drain completely.
7.
Fill the basin with warm water up to its level.
8.
Apply EPA-registered disinfectant according to its direction.
9.
Run whirlpool for 5 minutes.
10. Drain completely.
11. Wipe out excessive water with soft cloth.
12. Repeat step 7 to 10, If necessary.
