Important Considerations
Electrical Service
A 110V, 60 Hz, 15 Amp GFCI protected grounded circuit must be used to supply power to each individual pedicure spa.
Water Supply
All plumbing connections must conform to local codes.
Water supply to the spa should be provided with adequate water pressure and water temperature.
Water pressure
To fill the basin correctly up to level, Normal water pressure of 30 to 80 P.S.I is required.
Water temperature
The hot water supply temperature must not exceed 140 . Adjust your hot water accordingly. For hot and cold water supply
fittings and drain fittings location, see below diagram .Carefully connect the water supply line to the appropriate fittings
located on the rear of the pedicure spa.
Back flow Preventive Device
All pedicure spas are pre-installed with Dual Back flow Preventive Device for the following state; CA, AZ, NV, OR, WA, and
NE
Hot Water
Supply
Inlet
Cold Water
Supply
Inlet
1-1/2” PVC Drain
Outlet
ALL Fittings are ½”NPS (Male)
Back of the pedicure spa
The pedicure spa Drain must meet local plumbing codes.
Check valve for Drain (not Provided) Must be installed by a licensed
plumber.
PLUMBING CONNECTIONS
Specification
Back flow preventive device for faucet: Vacuum Breaker comply with ANSI/NSF - 61-2000, ASMB A112.18.1-2000, ASSE
1014 and CSA standard - B125.98.
Drain Facilities
ANSI/ASME A112.18.3M (performance requirements for back flow preventive device and systems in pluming fixture fittings)
is applicable to plumbing fixture fittings with outlets not protected by an air gap. Included in the possible range of applications
are fittings with hose connected outlets, fitting with pull out spout, hand held showers, shampoo fittings and deck mounted
fittings. ASME A112.18.3M is now referenced in ASME A112.18.1M (plumbing fixture fittings) and CSA B125. Back flow
preventive devices are listed to both standards with the canadien standard association, IAPMO and UL.
ANSI - American National Institute, ASME - American Society of Mechanical Engineers, CSA - Canadian Standard
Association IAPMO - International Association of Plumbing and Mechanical Officials, UL - Underwriters Laboratory
