Salora 8720085000871, Instruction Manual

EN 

2 

Battery back up 

The clock time and alarm (if set) can be maintained during a power failure by 2 x AAA/ LR03 
batteries (not supplied). 
Once the power is restored, check the time to make sure it is accurate and re-set if necessary. 

Inserting the Batteries 

1. 

Open the battery compartment at the bottom of the unit by pressing on the catch and 
removing the cover. 

2. 

Insert 2 x AAA/ LR03 batteries (preferably alkaline batteries) into the battery compartment, 
following the polarity as shown on the diagram inside the compartment. 

3. 

Replace the battery compartment cover. 

Setting the clock and alarm 

Setting the clock 

1. 

Press and hold the 

TIME (12) 

button

and the hour/minute digits will flash. 

2. Use 

the 

HOUR (10) 

button to set the hours.   

3. Use 

the

 MINUTE (11) 

button

to set the minutes. 

4. Press 

the 

TIME (12) 

button

again to confirm the clock time setting and the hour / minute 

digits will become solid. 
 

Setting the alarm 

Before setting the alarm time, make sure the clock has been set. 
1.  The unit remains in the standby mode. 
2.  Press and hold

 ALARM 1 (7) / ALARM 2 (6)

 button for 2 seconds and the hour / minute digits 

will flash. 

3. Press 

the

 HOUR (10)

 button to set the hours. 

4. Press 

the

 MIN (11)

 button to set the minutes. 

5.  The unit will then return to the clock time display after 5 seconds. 

Using the alarm function 

This unit allows you to wake up by buzzer or radio. 
1. 

The unit remains in the standby mode. 

2. 

To adjust the alarm time, follow the steps in “Setting the clock and alarm”. 

3. 

To select the buzzer or radio mode for 

ALARM 1

, press the 

ALARM 1 (7) 

button repeatedly. 

The corresponding 

AL1 buzzer Indicator (2)

 or 

AL1 radio Indicator (2)

 will light up on the 

LED display. 

4.  To select the buzzer or radio mode for 

ALARM 2

, press the 

ALARM 2 (6) 

button 

repeatedly. The corresponding 

AL2 buzzer Indicator (5)

 or 

AL2 radio Indicator (6)

 will 

light up on the LED display.

5. 

When the preset alarm time is reached, the alarm will sound in the 

selected alarm buzzer 

mode

 or radio will sound in the 

selected alarm radio mode

. 

6. 

To stop the alarm, press the     

 ON/OFF (8) 

button. The alarm will sound again at the 

same time the next day.   

7. 

To disable the alarm function, press the 

ALARM 1 (7) or ALARM 2 (7) 

button repeatedly 

until the 

selected buzzer indicator 

or 

radio indicator 

disappears.