Using the Alarm Function
1. To enable the alarm function, use the
ALARM 1/2
buttons (9) (10) to select buzzer or
radio. The selected alarm mode indicator will light up.
2. The buzzer or radio will come on at the set time.
3. To stop the alarm, press the
AL OFF
button (7). The alarm will sound again the next day.
Note: While the buzzer alarm volume is fixed and cannot be adjusted, the radio alarm
volume can be adjusted to your desired level using the VOLUME buttons (9) (10). To
select a radio station to wake up to, see the section on “USING THE RADIO”.
Snooze function
When the alarm sounds, press the
SNOOZE
button (12). The alarm mode indicator will
flash and the alarm will sound again after 9 minutes. To cancel the SNOOZE function
and repeat the alarm the next day, press the
AL OFF
button (7)
.
Sleep Function
With this function, you can listen to the radio for up to 90 minutes, after which it will
turn off automatically.
1. When the unit is switched on, press the
SLEEP
button (11) repeatedly to select the
duration: 90, 80, 70, 60, 50, 40, 30, 20, 10 minutes or OFF.
2. At the end of the set time, the radio turns off automatically.
3. To cancel the sleep function before the end of the set time, press the button to
turn off the radio immediately.
1. Press the button (7) to turn on the radio.
2. Press and hold one of the
<TUNING>
buttons
(5) (8)
to start automatic tuning up/
down. Release the button when the unit is receiving a station you would like to listen
to. For manual fine-tuning, you can press it briefly to adjust the frequency step by step.
3. Press the button (7) to turn off the radio.
For optimum reception
Extend and position the FM antenna to achieve optimum reception.
Preset radio stations
You can store up to 10 stations.
1. Use the
<TUNING>
buttons
(5) (8)
to search for a station. Press and hold
the
MEMORY
button to store the station and a number to be assigned for
the preset will be flash.
2. Press the
<TUNING>
buttons to change the number.
3. Press the
<MEMORY>
button again to confirm the setting.
Listening to a preset station
While listening to the radio, press the
MEMORY
button to select a preset station.
The current time is always displayed. When you change to Radio mode, the frequency
will be displayed for 5 seconds and then the unit will go back to displaying the time.
To charge, connect your USB device like smartphone to the USB port of this clock. Use
only with devices that require 5V USB power. USB port provides 1000mA recharging
USING THE RADIO
USB CHARGING FUNCTION
9
EN
