1
Installation Instructions
TGS01B
Salt Spreader
—continued inside
WARNING
Observe the following Safety Precautions before, during
and after operating this spreader. By following these pre-
cautions and common sense, possible injury to persons
and potential damage to this machine may be avoided.
SPREADER WARRANTY INFORMATION
This warranty replaces all previous warranties and no
employee of this company is authorized to extend addi-
tional warranties, or agreements, or implications not
explicitly covered herein.
Buyers Products Company warrants all parts of the
product to be free from defects in material and workman-
ship for a period of one (1) year. Parts must be properly
installed and used under normal conditions. Normal wear
is excluded.
Any part, which has been altered, including modifica-
tions, misuse, accident, or lack of maintenance will not
be considered under this warranty.
The sole responsibility of Buyers Products Company
under this warranty is limited to repairing or replacing any
part(s), which are returned, prepaid, 30 days after such
defect is discovered, and returned part(s) are found to be
defective by Buyers Products Company.
Authorization from Buyers Products Company must
be obtained before returning any part. The following
information must accompany defective parts returned
to Buyers Products Company: RMA #, spreader model,
serial number, date installed, and distributor from whom
purchased.
Buyers Products Company shall not be liable for damage
arising out of failure of any unit to operate properly, or
failure, or delay in work, or for any consequential dam-
ages. No charges for transportation or labor performed
on any part will be allowed under this warranty.
Safety Precautions
1.
Read this entire Owners Manual before operating
this spreader.
2.
Read all safety decals on the spreader before
operating.
3.
Verify that all personnel are clear of the spreader
spray area before starting or operating this spreader.
4.
Do not adjust, clean, lubricate or unclog material
jambs without first turning off the spreader.
5.
Make sure the spreader is securely fastened to the
vehicle in accordance with this manual.
6.
Do not operate a spreader that is in need of main-
tenance or repairs.
7.
Always disconnect the battery before removing or
replacing electrical components.
Spreader Assembly
Check contents of box against parts list to make sure
all components are included. When ordering replace-
ment or spare parts refer to parts list
(fig. 3)
for part
numbers.
Installation
(fig. 1)
1.
Locate and mark center of tailgate.
2.
Assembly Angles (24) and Braces (23) as shown in
Fig.1 Use 3/8" carriage bolts, flat washers and nuts.
Do not tighten fasteners at this moment.
3.
Center assembly on top of tailgate. Lower angle
must be flush with top and inside surfaces of tailgate.
9049 Tyler Blvd. • Mentor, Ohio 44060
Phone (440) 974-8888 • Fax (440) 974-0165
Toll-Free Fax 800-841-8003 • saltdogg.com
