Salter Brecknell C3235, User Instructions

12

2.

Place the scale on stable, level surface and turn the unit on.

3.

After the self-check is complete, press and hold the 

TARE

 key 

until…

CAL

 is briefly displayed, then 

0

.

4.

Empty the scale and press the 

TARE

 key to set the zero point.

Hg or Lb is displayed.

5.

Toggle between the choice of calibration weight unit of measure 
using the 

F

 key. When the unit of measure you want to use is 

displayed, press the 

TARE

 key…

The full capacity will flash.

6.

Load the full capacity weight onto the scale platform and press the 

TARE

 key.

CAEnd

 (calibration end) will briefly display, then the unit returns 

to normal weigh mode.

If you replace the PCB or loadcell, the scale requires recalibration. If the 
display shows 

Err-0

 after power up, it means there is a problem with 

calibration. Press and hold the 

TARE

 key to enter calibration and repeat 

the calibration process.

Multipoint Calibration:

Follow these steps for multipoint calibration of the scale. You will need test 
weights equal to 1/3, 2/3 and full capacity.

1.

Place the calibration switch, located on the bottom of the scale into 
the ON position. You may need to remove the small cover to access 
the calibration switch. Use a small screwdriver to remove the two 
screws holding the cover.

2.

Place the scale on stable, level surface and turn the unit on.

3.

After the self-check is complete, press and hold the 

F

 and 

ZERO

keys until…

20

 or 

100

 is displayed. This stands for the powerup zero range.

4.

Repeatedly press the 

F

 key to toggle between the two choices: 

20

and 

100

. When your choice is displayed, press the 

TARE

 key…

Lb

 or 

Kg

 is displayed. This is the calibration unit of measure.

5.

Press the 

F

 key to toggle between the two choices. When your 

choice is displayed, press the 

TARE

 key…

Scale full capacity is displayed.