Figure 2
3.
Place the trolley up-side down, connect the earth lead, the washers and fasten the three nuts. (Figure 3)
Note:
At this stage only tighten the nuts finger tight.
Figure 3
2.3
Replacing the rear cell
1.
Position the cell on the top of the trolley frame and insert the three screws through the holes in the cell
and the trolley (Figure 4).
2.
Channel the wire from the load cell through the holes in the frame and along the plastic wire channel strip
running the length of the trolley, to the PCB board located beneath the front cover plate.
