OWNER’S MANUAL V.102021 ENGLISH
M-9530 ELLIPTICAL KOR
This manual can be downloaded on
www.salter.es
ASSEMBLY INSTRUCTIONS
f. Attach the
Rear Stabilizer
(91)
onto the
Main Frame (1)
and secure with 2pcs
Washers (8x38x2.0t)(104)
,
2pcs
Lock Washers (M8)(100)
and 2pcs
Bolts (M8Xp1.25x60mm)(139)
. NOTE: If the item is not level, review
the
LEVELING NOTE
on the right side to level the
Levelers (90).
NOTE:
For shipping purpose,
Upright Post Cover (34, 35)
already pre-attached to the
Mina Frame (1)
. To
continue the following assembly, please remove 4pcs
Bolts (M5xp0.8x15mm)(127)
from the
Main Frame (1)
.
STEP 2 – Connection Wire Assembly
Plug the
Connection Wire B (94)
into the
Connection Wire C (95).
Be careful not to pinch the wires.
STEP 3 – Upright Post Assembly
a. Refer to the drawing on the right, insert the
Upright Post (46)
into the
Main Frame (1)
and make sure the upright post’s welded bolts go into the screw hole of the front
bracket located in front of the main frame. And slightly attach
2pcs Nylon Nuts
(M10xp1.5)(114)
. Note: please do not fully secure
2pcs Nylon Nuts (M10xp1.5)(114)
first for letting the Upright Post to assemble properly.
b. First fully secure with 2pcs
Bolts (M10xp1.5x20mm)(142)
at the front of the
Upright
Post (46)
. Then go back to fully tighten with
2pcs Nylon Nuts (M10xp1.5)(114)
.
