12
USER MANUAL - CM1000-ENG-09-22
Light indications can be customized for the following three device states:
4.3 LED’s and Buzzer Feedback Configuration
Idle:
Device normal state, nothing to perform, waiting for user interaction. The LED(s) remains
in this state until a user interaction is detected.
Access Granted :
Feedback when a valid PIN code or NFC tag is used to grant access. The
LED(s) and buzzer audio indication, remains in this state as long as the Output is Active.
Key Touched:
Feedback when a key is touched. Buzzer audio indication and LED(s) remains
in this state (blinks) for 500ms.
To customize a selected state, use the keys 1, 2 and 3 to turn ON or OFF the Yellow, Green and Red
LED’s respectively. Besides, the buzzer behavior can also be customized for the
Access Granted
and
Key Touched
states by using the key 0, if the buzzer is not muted in this state, a constant beep
can be heard.
#
Enter:
The LED indications has been changed. The keypad go back to LED’s and Buzzer
Feedback Configuration menu, and is ready to chose another state to be customized.
All three LEDs will turn ON until a device state to configure
is selected:
To customiz the LED indications first insert:
Enter:
2
0
#
Enter:
1
#
to configure
Idle
user feedback
Enter:
2
#
to configure
Access Granted
user
feedback
Enter:
3
#
to configure
Key Touched
feed-
back
The device shows the selected state LED’s feedback, and
for
Access Granted
and
Key Touched
states, also the
Buzzer feedback by a constant beep if it’s not muted.
Now it is posible to customize the state feedback.
LED’s
Values for LED
selection:
1
2
3
0
Use the corresponding key to turn ON or OFF the wanted LED or Buzzer
When the customization is done,
push # to save the configuration
