All contents current at time of publication.
SALTO Systems S.L. reserves the right to change availability of any
item in this catalog, its design, construction, and/or materials.
221373-ED.1-31/01/2019
Installation guide
SALTO LA1T07xx/LA1T17xx mortise locks for AElement
Hand changing
Changement de main
Cambio de mano
F
E
Eng
F
Installation guide
Guide d'installation
Guía de instalación
Eng
E
Installation
Installation
Instalación
E
Eng
F
PREPARING THE DOOR
1.Draw a horizontal line on edge of the door and on inside at the desired height of handle above floor.
2.Draw a vertical centre line on door edge.
3.Draw a vertical line on inside at the proper backset to align the template.
4.Mark ONLY top and bottom holes of mortise cavity (A).
Place lock face against door edge. Trace outline of faceplate as guide for faceplate routing.
5.Mortise door for lock body and faceplate.
6.Mark holes in the lateral face of the door for turnpiece (B) and
handles (C and D). Mark the holes for the corresponding electronic escutcheon fixings.
NOTE: See 3-4 pages for reader fixing holes depending on AElement model.
INSTALLING THE LOCK BODY
1.Insert wires through hole.
2.Insert the lock into the cavity.
3.Mark & drill mortise lock's fixing holes.
Fasten backplate and front plate with screws to hold lock in place.
INSTALLING THE STRIKE
1.Center strike to lock’s frontplate center line.
Refer to latch to determine strike location on jamb.
Using strike as template, mark and chisel recess.
2.Drill holes for dust box. Place dust box and strike and fasten screws.
Please check that:
- Deadbolt and latch fit the cavities of the strike without touching it.
- Gap between door and jamb is 1/8”.
(C)
L
C
OF
BACKSET
(A)
(A)
(B)
L
C
OF
FRONTPLATE
(D)
OF
LEVER
L
C
H
EIG
H
T A
BO
VE
F
LO
O
R
OF
LEVER
L
C
(D)
READER
HOLES
DEPENDING
ON AELEMENT
MODEL
Eng
TORX 10
4-3/8"
(110)
1-5/8"
(41,2)
q
5/16"
(
q
8)
1-1/2"
(38,1)
6-1/8"
(156)
2-3/4"
(70)
27/64"
(10,7)
3/4"
(19)
1-1/16"
(26,5)
LA1T17xx.. mod.
8"
(203)
1-1/16" (27)
1-1/4" (32)
LA1T17xx.. mod.
LA1T07xx.. LA1T17xx..
All contents current at time of publication.
SALTO Systems S.L. reserves the right to change availability of any
item in this catalog, its design, construction, and/or materials.
4
8
- S 8 D - - - - -
1 7
EN 14846:2008
1121-CPR-NA5003
SALTO SYSTEMS, S.L.
Pol. Indust. Lanbarren, c/Arkotz, 9
20180, Oiartzun-Gipuzkoa. Spain
1121
LA1T07 / LA1T17
Electromechanical lock for fire doors
1
2
3
5
6
7
TURN 180º
GIRO 180º
GIRE 180º
ANSI handing code
ANSI code de remise
Código mano ANSI
F
E
Eng
1/4
