4
22. Always operate the appliance on a smooth, even, stable surface. Do not place
the unit on a hot surface.
23.
Ensure that the switch is in the “Off” position after each use.
24. The manufacturer does not accept responsibility for any damage or injury caused
by improper or incorrect use, or for repairs carried out by unauthorised
personnel.
25. In case of technical problems, switch off the machine and do not attempt to repair
it yourself. Return the appliance to an authorised service facility for examination,
adjustment or repair. Always insist on the use of original spare parts. Failure to
comply with the above mentioned pre-cautions and instructions, could affect the
safe operation of this machine.
26. Always ensure that the fireguard is firmly in place before using the heater. This is
in place for your safety to prevent direct access to the heating elements.
Do not
touch the fireguard while the heater is on
. The fireguard gets very hot and you
may get burnt.
27. DO NOT COVER THE HEATER.
PLEASE NOTE
: When this heater is used for the first time, the heater will emit a smell of
burning and some smoke. This is normal and is caused by the insulation on the
elements and some dust particles on the elements. The smell and smoke will stop after
approximately 5 minutes.
ASSEMBLY INSTRUCTIONS
Remove all parts from the box. Arrange the parts on a stable surface, within easy
reach.
Gently insert the electrical cable from the top of the unit (the part with the fireguard)
into one of the tubes. Insert the narrow section of the tube into the centre of the top
of the unit, and secure it using three of the small screws.
Gently insert the electrical cable from the bottom of the unit (the part with the wheels)
into the second tube. Place the wide section of the tube over the centre of the bottom
of the unit, and secure it using three of the small screws.
Gently insert the remainder of the electrical cable from the bottom of the unit into the
third tube. Place the wide section of the tube over the narrow section of the second