5
tube (the one attached to the bottom), and secure the two tubes together using three
of the small screws.
Now connect the two sections of electrical cable, making sure that the blue wires
match up on corresponding sides of the connector. Do not match a blue wire with a
red wire. Press the two sides of the connector together until they click together
securely, and cannot be pulled apart.
Place the wide section of the top tube over the narrow section of the middle tube and
secure the two tubes together using the last three small screws.
Check that all the screws are secure and tight.
Should a shorter heater be required, leave off one of the tubes, inserting the excess
electrical cable into the base of the unit and the bottom tube.
OPERATING INSTRUCTIONS
Place the heater on a stable floor surface, away from curtains, clothes and any other
flammable materials. Make sure the switch is in the O
ff “O” position.
Place the wheels all in a locked position, by pressing down on the locks on each
wheel. This will ensure the unit is secure while in use. To unlock the wheels, lift the
locks on each wheel.
Plug the heater into the wall socket and switch on the wall socket.
Switch the heater on using the On/Off switch located on the base of the unit:
O
– the unit is off
I
– the unit is on
PLEASE NOTE
: It is recommended that the unit always be plugged into a wall
socket that is indoors. Should the need arise to use an electrical extension cable,
please ensure that the connection is water proof, and protected from moisture at all
times. Do not leave the plug where it can become wet, and do not leave the electrical
extension cable outdoors when not in use.
When you no longer need the heater, switch it off using the switch located on the
base of the unit. Then switch off the wall socket, and unplug the heater. Do not leave
the heater connected to the power outlet when not in use.
CLEANING AND MAINTENANCE
This appliance is for household use only and is not user-serviceable.
